27 10 070Replacing output flange on rear transfer box (ATC 35L)

Important!

After completing repair work, check transmission oil level and top up if necessary.

Use only the approved transmission oil.


Note:
  • Replace output flange only together with a new radial shaft seal.
  • Operations for removal of output flange are identical to replacing radial shaft seal for output flange.

Installation note:
  • Thickness of new shim must be determined before output flange is installed.

Determine and note down dimension A of output flange (old and new).
Determine and note down dimension B of output flange (old and new).
Determine old dimension C, thickness of shim.
Installation note:
Calculate thickness of new shim:
  1. Add old dimension A of output flange (previous) and old dimension C of shim

    Then subtract old dimension B from old result A+C

  2. Subtract dimension B from dimension A of output flange (new)
  3. Then subtract result of step 2 from result of step 1.

Sponsored links