13 62 531Replacing temperature sensor for coolant (S50)

Interrogate fault memory of DME control unit.

Switch off ignition.

To illustrate locations for installation of temperature sensor more clearly, intake air manifold is shown as removed.

S50 B30:

Unfasten plug connection (1). Unscrew and remove temperature sensor.

Tightening torque,

refer to Technical Data 13 62 2AZ

Installation:

Check coolant level and, if necessary, top up coolant.

Interrogate fault memory of DME control unit, check faults in memory, rectify faults and clear fault memory.


S50 B32:

Disconnect connector. Unscrew and remove temperature sensor.

Tightening torque,

refer to Technical Data 13 62 6AZ

Installation:

Replace sealing ring.

Check coolant level and, if necessary, top up coolant.

Interrogate fault memory of DME control unit, check faults in memory, rectify faults and clear fault memory.


Sponsored links